Log in Launch Studio

Polymer · Young's Modulus

Young's Modulus of PETG

The young's modulus of PETG is approximately 2.1 GPa. Stiffness under tension — the key input for structural FEA.

Young's Modulus of PETG

2.1 GPa

Ranked #48 of 53 materials by young's modulus

Compared to nearby materials

Nylon 6	2.7 GPa
Polycarbonate	2.4 GPa
ABS	2.3 GPa
PETG	2.1 GPa
Polypropylene	1.5 GPa
HDPE	1.1 GPa
PTFE (Teflon)	0.5 GPa

← All properties of PETG

Related products

Long-Run Extension +2h

Extend a single cloud job's wall-clock limit by two hours.

Compute & CreditsView →

Surrogate Instant Preview

Build an AI surrogate model for near-instant parameter previews.

Premium ToolsView →

CFD Pro Pack

A professional computational-fluid-dynamics toolset and templates.

Bundles & KitsView →

Grant / Publication Figure Package

Publication-ready figures and animations from your results.

Expert ServicesView →

Solver Method Recommendation Report

Describe your problem; get the recommended method and settings.

Reports & IntelligenceView →

Live Monthly Office Hours

A live Q&A session with a simulation specialist.

Courses & TrainingView →

Disclaimer. PolySim OS is a simulation and modeling platform, not a certified engineering, scientific, or professional-advisory service. Simulation results, material properties, and generated outputs are provided for research, educational, and informational purposes only and are not a substitute for physical testing, professional engineering judgment, peer review, or regulatory certification. No warranty is made as to the accuracy, completeness, or fitness for any particular purpose of any result produced by the platform. Always validate critical results against experimental data and qualified professional review before relying on them.

Property values and figures shown are typical/representative ranges compiled for reference and may vary by source, grade, temperature, and processing. Verify against primary sources before use in design.